Anki
Cart cart

 

Was this article helpful?
72 out of 233 found this helpful
Troubleshooting charging Issues

Avatar
Customer Care
Updated

If you would like to know more about minimum requirements for charging Vector, how long Vector’s battery lasts, and some tips on where the charger should be placed, please see this FAQ.

If you encounter any issues with the battery, charger or Vector finding his charger, please continue reading for troubleshooting steps.

Sections:

Vector is unable to find his charger

If you have come home to find Vector’s battery died before he found his charger, or you observe him struggle to find his charger, he may be not be able to see where it is, get to it or he may also have gotten stuck, half off a table edge. Please check the following:

  1. Make sure the charger is on a hard, flat surface that does not vibrate and is non-reflective and opaque (i.e. not a glass table)
  2. The Charger should be near to Vector and there should be a clear path for him to dock
  3. If Vector is in his Space, make sure his cube is not in there with him since it will obstruct his way to the charger
  4. Make sure the charger is visible to Vector. His eyesight is not as good as ours and he can be “blinded” by direct light (natural from sun through windows or artificial). Likewise, poor lighting makes it hard for Vector recognise his charger
  5. If he still has issues, check his camera is working and he can recognize the “home” icon on his charger. You can test his camera by having him recognize his cube or a face he has already met

Check Vector’s battery

To check Vector’s battery is working as expected, follow these steps:

  1. Turn Vector on by pressing his Back Button
  2. Leave him off the charger until the battery dies
  3. Turn Vector on again
  4. You should see the charging icon on his screen
  5. Vector should then shut down shortly afterwards
  6. If he does not do this, check his battery in the Customer Care Info Screen. See steps below

Use the Customer Care Info Screen (CCIS):

  1. Place Vector on his charger and plug the charger in
  2. [If Vector is booting up, wait for the “V” to finish]
  3. Double click Vector’s Back Button
  4. Raise and lower Vector’s lift
  5. Lower and raise Vector’s head
  6. Press his Back Button 3 times
  7. BATT: on the charger, you should see levels at around 3.6V (3.4V-4.21V). Note that initially, you may see 0.2V
  8. CHGR: on the charger, you should see levels around 4.9V with slight fluctuations. If the charger level does not change, contact Customer Care
CONTACT CUSTOMER CARE